DIY Interwoven Cords Bracelet

Do you always think of completing your outfit with some jewelry accessories? Do you know how to make jewelry by yourself? If you want to spend little money on the jewelry accessories, you can just follow these steps and do a Bracelet by yourself.

What needed:

  • Leather Cords
  • Beads
  • Glue
  • Jewelery Starter Kit
  • End caps
  • Wire

01

Step 1.
Cut 4 cords each measuring 60 cm. Double over. Tie on a cord and secure.

02

Step 2.
Now plait as shown. Place the leftmost cord over and down between the 3rd and the 4th on the right side.
03

Step 3.
Place the rightmost cord over and down between the 2nd and the 3rd on the left side and back again.
04

Step 4.
Continue by changing side.

05

Step 5.
Tighten.

06

Step 6.
Continue until the piece measures approx. 16 cm.

07

Step 7.
Put beads onto a wire which is put through a crimp bead, the eye of the end cap and back again. Close the crimp bead.
08Step 8.
Same procedure in the other side, but through the eye of the lock. Glue the ends of the leather cords together and glue into an end cap. Fit on a round jump ring in the opposite side of the clasp.

09

10 cord-bracelet-i